American Standard 2555.901.002 Installationsanleitung PDF herunterladen

TOWNSQUARE

Certiﬁed to comply with ANSI A112.18.1M

ROUGHING-IN

DIMENSIONS

Required Tools

Wrench

(Supplied)

Turn off hot and cold water supplies before beginning.

CAUTION

Insert SPOUT SHANK (1) through center hole of MOUNTING LEDGE.

Make sure that the RUBBER RING (2) is properly seated in RECESS

at base of SPOUT (3).

Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto

SHANK (1). From underside of ledge secure SPOUT (3) into position

with LOCKNUT (6).

SPOUT ASSEMBLY

PREPARE TUBE AND TEE ASSEMBLY

Prepare TUBE and TEE ASSEMBLY (1) to ﬁt center to center

VALVE (2) location (between 6-1/2" and12"). If necessary,

cut and/or bend TUBING carefully. Make sure tube bend is

close to the TEE (1) so that it will not effect the compression

joint at the VALVE CONNECTION.

Remove COUPLING NUT (3) and FERRULE (4) from each

VALVE (2) and slide onto TUBING (5).

Adjustable Wrench

Channel Locks

2555.900

2555.901

Flat Blade Screwdriver

VALVE inlet is 3/4-inch NPT male connector.

NOTE

ADJ. 6-1/2 TO 12

RECESS

MOUNTING

LEDGE.

MOUNTING

SURFACE

8-1/4

3-5/8

ADJ. 6-1/2 TO 12

1-1/2 MAX.

1-1/4

MAX.

1-3/16 D.

(H)

(C)

1-1/8 D.

3/4-14 MALE

N.P.T. INLETS

12 MAX

1-1/16 D.

Phillips Screwdriver

M968788 Rev. 1.2

DECK-MOUNT BATH FILLER

Installation

Instructions

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

1 2 3

Inhaltsverzeichnis

Seite 1 - Instructions

TOWNSQUARECertiﬁed to comply with ANSI A112.18.1MROUGHING-INDIMENSIONSRequired ToolsWrench(Supplied)Turn off hot and cold water supplies before beginn

Seite 2 - DECK ADAPTER

10355/16'' MIN.MOUNTING SURFACE1111101113Push TUBING (4) ends into VALVE (5) side outlets. Insert VALVES (5)into mounting holes from undersi

Seite 3 - HOT LINE FOR HELP

Hex wench, supplied8To change direction of handle rotation, proceed as follows:Turn valve to OFF position.Pull out INDEX CAP (1) and removeHANDLE SCRE